Air mover calculator
The IICRC Airmover Calculation Worksheet (Imperial revision 7.1.22), room by room: one unit per affected room, one per 50 to 70 square feet of wet floor, one per 100 to 150 square feet of wet wall and ceiling above two feet, and one per inset or offset deeper than 18 inches. Fractions round up.
Rooms
Enter each affected room. Wet floor excludes walls; wet wall and ceiling means the area above about two feet.
Air movers
8 to 10
Air movers
3
Low range, whole job
11
Floor ÷ 70, wall ÷ 150, plus rooms and offsets
High range, whole job
13
Floor ÷ 50, wall ÷ 100, plus rooms and offsets
| Room | Step 1 room | Step 2 floor (low / high) | Step 3 wall and ceiling (low / high) | Step 4 insets | Total (low / high) |
|---|---|---|---|---|---|
| Cafeteria | 1 | 5 / 6 | 1 / 2 | 1 | 8 / 10 |
| Hallway | 1 | 2 / 2 | 0 / 0 | 0 | 3 / 3 |
Lower walls and limited flooring
When water migrated less than two feet into the room: one air mover per 14 affected linear feet of wall. Not combined with the room method above.
Air movers
3
42 ÷ 14, rounded up
Standing water
Length × width × depth in feet is cubic feet; × 7.48 is gallons. Three inches is 0.25 feet.
Cubic feet
75.0
Gallons
561
× 7.48 gallons per cubic foot
How the calculation works
Step 1. One air mover in each affected room, counted in both the low and the high range.
Step 2, floor. Wet floor square footage divided by 70 gives the low range and divided by 50 the high range. The floor figure includes the lower walls up to about two feet, so measure the floor only.
Step 3, wall and ceiling. Wet wall and ceiling square footage above about two feet divided by 150 (low) and by 100 (high).
Step 4, insets and offsets. One more for each wall inset or offset greater than 18 inches, in both ranges. Each fraction rounds up to the next whole unit before the steps are added.
Two notes from the worksheet. In a room under about 25 square feet one air mover may be adequate. And when water migrated less than two feet into the room and mainly affected the lower walls, the worksheet uses one air mover per 14 affected linear feet of wall instead; that method is not combined with the square-foot method in the same room.
These are initial counts. ANSI/IICRC S500 expects daily readings to drive adjustments after that. For the dehumidification side of the same job, use the dehumidifier calculator ; the worked example in how many air movers and dehumidifiers a water job needs walks through both.
Sources
Questions this tool answers
- How many air movers do you need per square foot?
- The IICRC Airmover Calculation Worksheet (Imperial revision 7.1.22) starts with one air mover in each affected room, then adds one for every 50 to 70 square feet of wet floor, one for every 100 to 150 square feet of wet wall and ceiling above about two feet, and one for each wall inset or offset deeper than 18 inches. Fractions round up, so a 300 square foot wet floor adds five to six units on top of the one for the room.
- How many air movers for a 12 by 12 room?
- With the whole 144 square foot floor wet and dry walls above two feet, the worksheet gives one for the room plus 144 divided by 70 (2.06, rounded up to 3) for the low range and 144 divided by 50 (2.88, rounded up to 3) for the high range: four air movers either way. Wet walls above two feet and insets add more.
- What if only the lower walls got wet?
- When water migrated less than about two feet into the room and affected mainly the lower walls, the worksheet uses a different rule: one air mover for each 14 affected linear feet of wall. That method stands on its own and is not combined with the square-foot method in the same room.
- Is the worksheet count the final count?
- No. It is the initial placement. ANSI/IICRC S500 expects the restorer to read and record conditions at least daily and adjust equipment to what the materials and the psychrometric readings show. Document the initial calculation and every change.
- How many gallons of water are in a flooded room?
- Multiply length by width by the depth of standing water, all in feet, to get cubic feet, then multiply by 7.48 for gallons. A 20 by 15 foot room with three inches (0.25 feet) of water holds 75 cubic feet, about 561 gallons.
More free tools
- Dehumidifier calculatorPints per day and unit count from room volume and class, using the IICRC initial dehumidification factors for conventional, LGR and desiccant units.
- Psychrometric calculatorGPP, dew point and vapor pressure from temperature and RH, and the grain depression across a dehumidifier.
- Restoration glossaryThe terms of water, fire, mold and claims work, defined plainly.
The app does this math on the job itself
AIFSOP suggests equipment from the scanned room volume, the class and the current readings, and logs every unit per area. 30-day free trial, no card.